Welcome to the
MIRATECH Solutions Guide

MIRATECH is the expert in providing fully integrated, proven exhaust compliance solutions for anyone using industrial engines in a Power Generation, Gas Compression and Mechanical Drives.

Review
Your Solution
Contact us for
Pricing & Details
continue

Tell us about your needs

Your selction did not return any results.
Please adjust your selection and try again.

Applications

  1. Gas Compression
  2. Power Generation
  3. Rail
  4. NESHAP Regulations
  5. Industrial
  6. Air Compression
  7. Liquids Pumping
  8. Bio-Gas
  9. Greenhouse CO2 Enrichment
  10. Industrial Marine

Engine Type

  1. Bi-Fuel Diesel and Natural Gas
  2. Diesel
  3. Natural Gas Lean Burn
  4. Natural Gas Rich Burn

Noise Control

  1. Yes
  2. No

Engine Size

  1. 20 to 200 hp
  2. 200 to 1350 hp
  3. 1350 to 10,000 hp
  4. 10,000 hp and above

Regulated Pollutants

  1. NOx
  2. NO2
  3. CO
  4. VOC (NMNEHC)
  5. HAP's
  6. Particulate Matter (PM)
RESET
 
continue

Submit your Request for Pricing and Details

Your Solution(s):

Contact Information

Error: Please complete form.


Thank You!
back
submit

Connecticut proposes regulations for NOx emissions from fuel burning equipment.

June 3, 2016

A May 18, 2016 Trinity Consultants report says the Connecticut Department of Energy and Environmental Protection (DEEP) published notice of intent to repeal the current Regulations of Connecticut State Agencies (RCSA)Connecticut DEP Logo Sections 22a-174-22 for control of nitrogen oxide (NOx) emissions and in lieu adopt two new regulations: RCSA 22a-174-22e and RCSA 22a-174-22f. The changes are proposed in order to make the NOx emission limits consistent with emission limits achievable through current reasonably available control technology (RACT).

In particular, the proposed new regulations include the following:

  • RCSA 22a-174-22e “Control of nitrogen oxides emissions from fuel-burning equipment at major stationary sources of nitrogen oxides” proposes a phased implementation of fuel specific NOx emissions limits for fuel burning equipment at major sources of NOx. The regulation also includes reemissions monitoring and testing, record keeping and reporting to enable sources demonstrate compliance with the emissions limitations.
  • RCSA 22a-174-22f “High daily NOx emitting units at non-major sources of NOx” requires the non-major sources of NOx to maintain the equipment in proper operating condition and track daily NOx emissions during the summer months. In case the daily NOx emissions exceed the levels specified, then sources will be regulated by CSA section 22a-174-22e.

What this means to you
Connecticut intends to adopt new regulations for NOx emissions from stationary sources. RCSA 22a-174-22e proposes a phased implementation of fuel specific NOx emissions limits for fuel burning equipment at major sources of NOx. RCSA 22a-174-22f requires non-major sources of NOx to maintain the equipment in proper operating condition and track daily NOx emissions during the summer months.

MIRATECH can help
Contact MIRATECH for information on NOX emission controls for your engines.